Tactic TTX610 6-Ch SLT - Manual (Page 9)

9
RECEIVER (Rx)
Mount the Rx as specified in the model’s
instructions. Wrapping the Rx with foam
rubber can help to prevent damage
resulting from vibration but could prevent
adequate airflow from passing over the Rx.
See the SERVOS AND ACCESSORIES
section for additional Tactic receivers.
SERVOS
Center all trims on the Tx. Install the servos in the model and
connect linkages as shown in the model’s instructions. Do NOT
over-tighten the mounting screws, as the servos should be able to
move slightly to compensate for engine vibration. Make sure the
pushrods are not too loose or bind in any way, and use a servo
arm which allows for full range of motion for the servo. This can
be tested by moving the Tx sticks to maximum positions several
times while observing the movement of the control services. Adjust binding servos/linkages to prevent excessive
draining of the battery. Move the Tx trims to finely adjust the servo’s center point as needed for the application.
Connect the servos to the Rx as shown. Route the wires to not interfere with moving parts.
Rudder
Servo
(Ch4)
Auxiliary
Servo
(Ch5)
Auxiliary
Servo
(Ch6)
Receiver
Throttle
Servo
or ESC
(Ch3)
Elevator
Servo
(Ch2)
Aileron
Servo
(Ch1)
Switch Harness
To Rx Battery
To Charger
6-CHANNEL RECEIVER
LINK
See the SERVOS AND ACCESSORIES section on page 12 for a full list of optional servos.
ELECTRIC MODELS
An optional ESC (electronic speed control) will be necessary to control speed of the electric motor, and
to supply power to the receiver and servos. Connect the ESC’s receiver plug to Rx slot marked CH3 (for
throttle). Center the transmitter’s throttle trim and follow the ESC instructions for proper operation and
connection of the battery.
RECEIVER and FLIGHT EQUIPMENT INSTALLATION (if applicable)
CH6 Auxiliary (Flaps)
CH5 Auxiliary (Landing Gear)
CH4 Rudder
CH3 Throttle (ESC or Servo)
CH2 Elevator
CH1 Aileron
BAT Battery
LED Link Button
Rubber Grommet
Brass Eyelet
Servo Servo Servo
Screw
Servo Tray
ELECTRIC and COMBUSTION POWERED APPLICATIONS