TC-Helicon VoiceLivePlay GTX Details manual - Manual (Page 9)

9
when pressed, the voiceLive play Gtx enters the setup menu, which is comprised of 9 pages and
controls the general functions of the device:
Mic Type – selects the type of microphone
there are 5 settings:
1 dynamiC miC– for dynamic mics (like an sm-58 or om5)
2 Condenser miC – for condenser mics (like a Beta 87a)
3 mp-75 or e835fx miC - for use with the mp-75 or e835fx microphones, which have an on
board switch to control various functions of your voiceLive play Gtx, such as the hit Loop
functions
*mic Control defaults to hit when mp-75 or e835fx is selected
5 usB – digital audio can be passed to the voiceLive play Gtx via the usB port allowing you to
send vocals from a daw to the unit for processing
Room Sense – Controls the way the two onboard roomsense microphones function
there are 3 settings:
1 amBient – roomsense uses the onboard mics and passes that signal via the headphone out
put Control for roomsense level can be found in the mix section to avoid feedback, the
roomsense output is only passed to the headphone output and not the xLr output
*try using the amBient setting alongside a vocal mic to pick up an instrument, like an acoustic
guitar or piano, and mix it in with your vocals you can also mix some of the amBient signal
into an in-ear monitor mix to give you room sounds with your direct mic feeds
2 amBient/auto – in addition to the ability to output roomsense sounds via the headphone
mix, the onboard roomsense mics will also listen to musical information from the surrounding
environment (a single instrument or even your whole band will work!) to determine the Key/
sCaLe for harmony/hardtune
3 voiCe – the roomsense mics are used as the primary vocal input this action is only available
via headphones
Setup - Input