TeeJet LH 500 - Manual (Page 18)

S ETTINGS LH 500 C OMBINE MONITOR OPERATORS MANUAL
WORKING WIDTH
Encode the total header width in centimetres.
HEADER HEIGHT ADJUSTMENT
Raise the header to the height at which area counting should be stopped then
press the RETURN key.
The current output from the header height sensor is shown in the display during
calibration.
WARNINGS
The following audible and visual warnings can be encoded:
Key Description
Warning on.
Warning off.
Chopper:
Warning for minimum chopper speed, plus warning on/off.
Thresher: Warning for minimum thresher speed, plus warning on/off.
Fan: Warning for minimum fan speed, plus warning on/off.
Grain elevator: Warning for minimum elevator speed, plus warning on/off.
Return elevator 1: Warning for minimum elevator speed, plus warning on/off.
Return elevator 2: Warning for minimum elevator speed, plus warning on/off.
Straw walker:
Warning for minimum walker speed, plus warning on/off.
Feed auger: Warning for minimum auger speed, plus warning on/off.
Reel: Warning for minimum reel speed, plus warning on/off.
Grain tank: Warning on/off for grain tank level.
We recommend switching off any warnings that are not used.
18 LH A GRO