ThermoProbe TP9 - Manual (Page 4)

11/2012, JK
USER INTERFACE
“Power” Button
Pressing the Power button once will turn on the device. The instrument will shut off automatically within 20 minutes.
Pressing the Power button twice (within 1 second) will save whatever reading is on the display.
Pressing and holding the Power button will and shut the instrument off and clear all logged and averaged readings.
Function “f” button
Press and Hold the Function Button “f” to display options in a menu
format. When the desired function is displayed release the button.
Up to 10 readings can be saved and averaged.
Backlight
When the instrument is operating in low-light conditions a photocell will detect this situation and permit the backlight to function.
Battery Check
When the voltage of the batteries is low, the device will indicate “Lo bAtt” on the display before resuming normal display functions.
When the batteries are low the backlight will not operate in order to conserve power while the user completes his operations. Replace
batteries as soon as possible in a safe location after “Lo bAtt” is noticed, this will ensure backlight operation, and avoid possible
malfunctioning. Do not attempt to calibrate the instrument if the “Lo bAtt” has been displayed since the new calibration values may
not be properly stored to memory.
Power button
Operation Display
One quick push Power On
Two quick presses
Saves current reading “LoggEd”
Hold and Release
when display reads “oFF”
Power Off
(Clears Readings)
“oFF”
Hold and Release when the
display reads:
Function (“f”) Example on Display
“LiSt”
displays all saved readings
“rEAd 1, 78.2 F”, “rEAd 2,
74.4 F”, etc.
“At”
displays the average of all saved readings “At, 76.3 F”
“C-F” Changes units “76.3 F” or “24.6 C”
“dEC” Changes units resolution (0.1 or 0.01) “76.3 F” or “76.36 C”
Power Button
Function Button