ThermoWorks 9150-X HART SCIENTIFIC 9150 THERMOCOUPLE FURNACE - Manual (Page 36)

CAL Calibration parameters menu
Press “SET” five times to enter the menu. The calibration parameters menu
contains the parameters Hard Cutout, CT1, CE1, CT2, CE2, CT3, and CE3.
8.12.1 Hard Cutout
This parameter is the temperature above which the unit shuts down automati-
cally. The parameter is set at the factory to approximately 1260°C and cannot
be changed by the user.
8.12.2 CT1, CT2, and CT3
The calibration parameters CT1, CT2, and CT3 are the calibration
temperatures.
8.12.3 CE1, CE2, and CE3
The calibration parameters CE1, CE2 and CE3 are the calibration errors corre-
sponding to the calibration temperatures.
35
8 Controller Operation
Calibration Parameters