Cabletron Systems CSX200 User Manual
Csx200 cyberswitch installation guide
Advertising
Table of contents
Document Outline
- Title Page
- Notice
- Contents
- Introduction
- About the CSX200
- CSX200 Hardware
- Remote Management Capabilities
- Optional Features
- CSX200 Firmware Support
- IEEE 802.3 Ethernet
- WAN Protocols
- Firmware Data Compression
- HDLC
- DHCP and NAT
- Frame Relay Protocol
- Point-to-Point Protocol (PPP)
- PAP and CHAP Security
- LQM
- Multilink Protocol
- ISDN
- HDSL
- Bridging and Routing
- Bridging and Routing Protocol Filtering
- System Passwords
- Simple Network Management Protocol (SNMP)
- Software and Firmware Upgrades
- 10BASE-T LAN Requirements
- Installation
- Troubleshooting
- Troubleshooting CSX200 Hardware
- Troubleshooting the LAN
- Troubleshooting the WAN
- Link (LNK) LED is OFF
- Link (LNK) LED is RED
- Link (LNK) LED is AMBER
- Status 1 (STS1) LED is OFF
- Status 1 (STS1) LED is RED
- Status 1 (STS1) LED is AMBER
- Status 1 (STS1) LED is GREEN
- Status 2 (STS2) LED is OFF
- Status 2 (STS 2) LED is RED WPIM-HDSL Installed in CSX200
- Status 2 (STS2) LED is AMBER
- Status 2 (STS2) LED is GREEN
- Test (TST) LED is AMBER (blinking)
- Investigating Software Configuration Problems
- WPIM Cable Specifications
- Specifications and Standards Compliance
- FCC Part 68 - User’s Information for CSX200
- Glossary
- Index