Toa WM-5320A - Manual (Page 6)

6
8. OPERATION
Step 1. Plug the microphone's plug into the input connector as illustrated.
Step 2. Confirm that the wireless microphone and the wireless tuner are identical in the channel number.
If not identical, turn the power ON/OFF switch to the OFF position, then set the channel number to the
same channel number as the tuner.
Step 3. Turn the Power ON/OFF switch to the ON position. Then, confirm the green LED of the Power/Battery
lamps will light.
For the WM-5320A, put the unit into the waist pouch as shown in the figure below.
Step 4. Turn the Power ON/OFF switch to the OFF position after use.
Secure the connection with the plug lock. Illustration for WM-5320A
Main unit (WM-5320)
Hook and loop fastener
Belt
Plug lock
Plug lock
Waist pouch
Channel setting switch
7. CHANNEL NUMBER SETTING
Step 1. Turn off the power switch, and then remove the battery
cover.
Step 2. Using the supplied screwdriver, set the Channel setting
switch pointer to the desired channel number.
Step 3. Replace the battery cover.
Note
Make sure that the wireless microphone is identical to the
wireless tuner in the channel number. Should the microphone's
setting differ from that of the tuner, the tuner does not receive the
microphone signal.