Toa C-BC850U - Manual (Page 6)

Guide hole
Decorative panel
(Accessory)
Projection
Guide rib
6. Install the camera to the flush ceiling mounting bracket.
Place 4 keyhole slots of the camera mounting bracket over the bracket mounting screws loosened in step 2,
rotate the bracket clockwise to align the
mark on the camera mounting bracket with that on flush ceiling
mounting bracket, and then tighten the bracket mounting screws.
7. Attach both the inner cover and dome cover to the camera after camera adjustment completion.
For details, refer to the instruction manual enclosed with the camera.
8. Attach the decorative panel.
Align the decorative panel's guide ribs (2 points) with the guide holes in the flush ceiling mounting bracket,
then insert the panel into the bracket. (Confirm that the decorative panel is securely fixed to the flush ceiling
mounting bracket.)
When detaching the decorative panel:
Pull down the decorative panel holding the portions around its 2 projections to detach the panel.
Note
When attaching the decorative
panel, check that the safety wire
connected to the decorative panel
is not pinched.
Decorative panel: PC resin, light gray
Mount bracket: Rolled steel plate, black, paint
ø227 x 80.6 (H) mm (8.94" x 3.17")
930 g (2.05 lb)
C-CV854D-3
Finish
Dimensions
Weight
Applicable camera
5. SPECIFICATIONS
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Camera mounting screw ( M4 x 10) ..................... 4
Decorative panel .................................................. 1
133-05-427-10
URL: http://www.toa.jp/