Top Flite TOPA0705 - Manual (Page 26)

26
❏
20. Look closely at the photo in step 19. You will
fi nd an elongated hole in the fuselage former. (Hole
for choke.) Feed the choke tube through this hole. The
tube should pass through the hole into the fuselage
approximately 5" [127mm].
❏
21. The forward opening is for the throttle servo. The
aft opening is for the choke. The tube for the choke
should be positioned as shown.
❏
22. In the front of the fuselage, glue the plywood
support for the choke tube to the former. Once the
glue has cured cut off the portion of the plastic tube
between the fi rewall and the plywood support as shown
in the photo.
❏
23. With the servo tray resting in place on the air
tank, make a mark on the fuselage formers to show
the location for the tray at each of the four corners of
the tray.
❏
24. 1/8" [3.2mm] below the marks you made make
another line. Glue a 3/8" Ч 1/2" Ч 5/8" [9.5mm × 13mm
16mm] hardwood block so that the top of the block is
aligned with the new line you just made. The tray will
rest on and be screwed into the blocks. Once the glue
has cured place the tray onto the blocks. Drill a 1/16"
[1.6mm] hole through the holes in the corners of the
tray into the blocks and then remove the tray.
❏
25. Install the battery and receiver to the tray. Insert
a piece of R/C foam under each and secure them with
Velcro
® cut from the 12" [305mm] piece included in
the kit. Using the same mounting method used for the
other servos, install the throttle, choke and air control