Top Flite TOPA0705 - Manual (Page 33)

33
❏
3. Position decal on the model where desired.
Holding the decal down, use a paper towel to wipe
most of the water away.
❏
4. Use a piece of soft balsa or something similar to
squeegee remaining water from under the decal. Apply
the rest of the decals the same way.
Refer to these pictures and the pictures on the box to
determine the location for the decals.
❏
5. The red stripe around the back of the fuselage is
applied in two pieces. The decal sheet clearly indicates
which half to apply to each side of the fuselage. Be
careful to apply the end of the stripe marked "Top of
Fuse", to the top of the fuselage.