Top Flite TOPA0905 - Manual (Page 34)

❏
6. Slide a silicone clevis retainer over the clevis
you soldered to the wire. Slide the threaded end of
the wire into the tube and attach the solder clevis to
the nylon torque link. Install the 4-40 nut threaded
clevis and silicone clevis retainer onto the threaded
end of the wire. Attach the clevis to the outer hole in
the servo arm as shown.
❏
7. Locate the coil of wire for the pull-pull system.
Cut it into two equal lengths. Install the hardware (2-
56 nut, thread brass coupler, silicone clevis retainer
and swag) onto one end of each of the wires and
crimp the swag.
❏
8. Attach each of the clevises onto the steering
arms of the tail wheel assembly (either the fixed tail
wheel or the retractable). Then, from the back of the
fuselage, insert the wires into the plastic tubes feeding
the wire up to the servo compartment.
❏
9. Assemble the hardware (2-56 nut, threaded
brass coupler, silicone clevis retainer and swag) and
the wire. Center the servo and the tail wheel, pull the
wires tight and then crimp the swag onto the wire.
Attach the clevis to the servo arm as shown.
❏
10. Install the pushrod wire and clevises for the
elevator using the same technique that was used for
the rudder. If you have a retractable tail wheel, solder
the 2-56 clevis to the pushrod wire for the retracting
tail wheel.
❏
11. Place the battery and receiver onto the foam
and hold it in place with the Velcro.
- 34 -