Cisco 3750 - Manual (Page 29)

2-11
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the four supplied number-12 Phillips machine screws
to securely attach the brackets to the rack, as shown in
Figure 2-8 .
Figure 2-8 Mounting the Switch in a Rack
After the switch is mounted in the rack, perform these tasks to complete the installation, run the setup
program, and access the switch:
• Connect to the console port, and start the emulation software. See the “Connecting to the Console
Port” section on page C-3 and the “Starting the Terminal-Emulation Software” section on page C-3 .
• Power on the switch. See the “Connecting to a Power Source” section on page C-4 .
• Run the setup program. See the “Completing the Setup Program” section on page C-5 .
• Connect to the front-panel ports. See the “Connecting to the 10/100 Ports” section on page 2-17 and
the “Connecting to an SFP Module” section on page 2-18 to complete the installation.
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, refer to the switch
software configuration guide or the switch command reference.
1 Phillips machine screws
PWR A
SYST
PWR B
MASTR
STAT
DUPLX
SPEED
STACK
MODE
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
1X
2X
11X
12X
13X
14X
23X
24X 1 2
3 4
CONSOLE
97435
1
Catalyst 3750 Metro
series
ES PORTS