Touchstone 80005 OnyxXL Fireplace - Manual (Page 4)

4
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, hammer.
Parts and Hardware
B – Wood Screws & Washers
( 5 sets )
C – Drywall anchors ( 3 )
A – Fireplace ( 1 )
D – M4x8 Metal Screws (2) RC – Remote Control
E - Wall Bracket (1)
Installation and Assembly
Rear View of Fireplace Step 1. Find a safe location.
Minimum clearance on each side:
19.7” (50 cm).
Minimum clearance below:
9.8” (50 cm).
Minimum clearance above:
39.4” (100 cm).
Minimum clearance from the front
and sides: 3 feet (90 cm).
Choose a location near an outlet so
an extension cord is not required.
DO NOT position the unit directly
below a power outlet.
See Safety Information on pages
2 and 3 for warnings about safe
placement, safe installation, and
proper use of this product.
19.7”
(50 cm)
Minimum 39.4”
(100 cm)
Minimum 9.8”
(50 cm)
19.7”
(50 cm)