Touchstone 80005 OnyxXL Fireplace - Manual (Page 5)

5
NOTICE
The wall mount fasteners included with this fireplace are for use ONLY with a
wood-framed wall covered in drywall (sheet rock). For concrete walls, cinder
blocks, or other wall types, consult a professional for the best attachment methods.
ALWAYS unplug this fireplace heater before assembly or cleaning, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.
STEP 2. A. Locate the wall studs using an electronic stud-finder. Mark the hole locations with a
pencil. The holes should be 8” (20.3 cm) apart, and level. The minimum height from the surface
below must be 75.2” (191 cm). B. Three screws should be screwed directly into wall studs. Then,
no drywall anchors are needed. C. If only two studs are available, two screws MUST be
screwed directly into studs, and the other screws must be screwed into the drywall anchors.
AVOID INJURY and DAMAGE! Three screws should be screwed directly into wall
studs. If only two studs are available, two screws must be screwed directly into the
wall studs, and additional screws must also be screwed into the drywall anchors.
Mounting into three wall studs Mounting into two wall studs and drywall anchors
STEP 3. Drill a pilot hole into each mark using a 1/4” wood drill bit. A. If screws will go into three
studs, no drywall anchors are needed. B. Tap the drywall anchor(s) (C) carefully into the drywall
holes until they are flush with the drywall surface. Use care to avoid damage.
Drywall
Studs
C
C
C