Traveler Guitar Pro-Series - Manual (Page 5)

STRINGING AND TUNING
INSTALLING STRINGS:
The Pro-Series uses standard, ball-end strings. (Factory installed D’Addario EJ-15.) No special tools are
required for string changes.
The tuners on your Traveler Guitar operate just like the tuners on a standard guitar. We recommend
changing the strings three at a time—but be careful not to remove all the strings at once, since some of the
components are held in place by string tension. First remove the old E, A, and D strings, and then install
three new strings in their places. Repeat this process on the G, B, and high E strings.
To change strings, thread the string through the correct hole in the endcap and wrap the string around the
string roller to the proper tuning machine hole. Leave approximately 2 ½ inches of slack in the string to
allow 3 to 4 wraps on the tuner. Bend the string to anchor it in place in order to hold the string after it is fed
through the tuner. Over or under wrapping the string around the tuning machine post may cause tuning
problems.
See videos here and here.