Ia. wiring using a clarion “t” harness, Ib. wiring using the supplied harness – Clarion PSWFRGR User Manual
Page 2
2
Ia.
WIRING USING A CLARION “T” HARNESS
•
STEP 1:
Remove the Radio.
•
STEP 2:
Connect the "T" Harness.
A. Unplug factory wires from radio.
B. Plug the "T" harness in line with the radio wiring. SEE DIAGRAM 1.
C. Connect the BLACK wire on "T" harness to radio chassis.
•
STEP 3:
Route the wire harness from the radio to transmission hump of the vehi-
cle.
•
STEP 4:
Connect the amplifier ground wire to a clean chassis ground near the
subwoofer enclosure.
STEP 5:
TEST and SET the GAIN.
A. Turn on the system and be sure all speakers are working properly.
B. Set the subwoofer amplifier gain to a suitable level.
There are 2 methods to connect this product to the vehicle. Please refer to section Ia and Ib for each.
Ib.
WIRING USING THE SUPPLIED HARNESS
•
STEP 1:
Remove the Radio.
•
STEP 2:
Connect the wires.
Yellow:
Connect to Constant 12V Power
Black:
Connect to Radio Ground or Chassis
Blue:
Connect to Amp/Antenna Turn-on Lead
Green:
Connect to Left Rear Speaker (+) Positive Lead
Green/Black: Connect to Left Rear Speaker (-) Negative Lead
Violet:
Connect to Right Rear Speaker (+) Positive Lead
Violet/Black: Connect to Right Rear Speaker (-) Negative Lead
•
STEP 3:
Route the wire harness from the radio to transmission hump of the vehi-
cle.
•
STEP 4:
Connect the amplifier ground wire to a clean chassis ground near the
subwoofer enclosure.
STEP 5:
TEST and SET the GAIN.
A. Turn on the system and be sure all speakers are working properly.
B. Set the subwoofer amplifier gain to a suitable level.