Triner Scale iForks Pt2 - Manual

OWNERS MANUAL – i Forks 21
6.7 Error messages
ERROR MESSAGES
Display Meaning Out of error mode
Err01 Load cell signal is unstable Automatic
Err02 Overload on full scale Automatic after removing weight
Err03 Gross negative. This action is not allowed Automatic
Err04 Out of zero range Press any key
Err05 Sampling accuracy too low Press any key
Err06 Input signal too high Automatic after correcting input
Err08 Calibration out of range (negative) Automatic
Err09 Calibration out of range (signal too low) Automatic
Err10 Calibration count 2nd(3rd) point lower than count
1st(2nd) point Automatic
Err14 Setpoint value 2 < setpoint value 1. This is not allowed Automatic
Err98 Calibration point must be higher than previous one Automatic
Err99
ErrF1
ErrF2
----
L - _
ErrCS Action only allowed in start-up units
Problem with fork 1 (no communication)
Problem with fork 2 (no communication)
Loadcell signal negative
Forks are out of level (only legal-for-trade version)
Problem with correction sensor Automatic
Restart indicator. Restart forks & indicator
Restart indicator. Restart forks & indicator
Lift up the forks from the ground
Put the forks into horizontal position
Contact the RAVAS Service department
DISPLAY MESSAGES
Display Meaning
BltF1
BltF2 Successful Bluetooth link with fork 1
Successful Bluetooth link with fork 2 No error
No error