Triner Scale PC DataLog User Manual
Page 7
Advertising
Page 1-4
7. Insert each wire into the corresponding terminal and tighten each screw
to secure the wire. Note: When connecting the wires, make sure the bare
ends of the wires are connected to the terminals.
8. Tighten the cable fitting nut to secure the cable in place.
9. Replace the back panel being careful not to pinch any wires between the
back panel and the enclosure.
10. Connect the female end of the cable to the male RS-232 Serial Adapter
Port on the computer.
11. Tighten the thumb screws to secure the connection.
Supplied RS-232 Cable
Wiring Block Located Inside TS-700 SS
FIGURE 1
Advertising