TRUE Systems P-SOLO - Manual (Page 2)

2
IMPORTANT SAFETY INSTRUCTIONS
Important Symbols:
This symbol indicates the presence of dangerous voltage within the product enclosure that
presents the risk of electric shock injury. When this symbol appears next to an operation
discussed in this manual, only qualified technical personnel should perform that operation.
This symbol indicates important operating or maintenance instructions that should be read
carefully. Failure to observe these instructions could result in damage to the product or other
property. Resulting damage will not be covered under warranty.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Clean only with dry cloth.
6. Install this unit in accordance with manufacturer’s instructions.
7. Only use attachments/accessories approved by the manufacturer.
8. Do not use this unit near water.
9. Do not place liquid-filled objects on this unit.
10. Do not operate this unit in the presence of rain, dripping or splashing liquids, or condensing
moisture. Liquid entering the product enclosure presents the risk of electric shock injury.
11. Do not touch the AC plug or enclosure with wet hands.
12. Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus
that produce heat.
13. Unplug this unit during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the unit has
been damaged in any way, such as power supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the unit, the unit has been exposed to rain or moisture,
does not operate normally, or has been dropped.
To reduce the risk of electric shock injury, do not remove the top cover or rear panel.
 Do not defeat the earth ground connection in the AC power cord.
 Do not defeat intended AC power connection polarization.
 Do not use a damaged or excessively worn cord to connect this unit to AC
power. Protect power cord from being walked on or pinched.
CAUTION: To disconnect this unit completely from the MAINS, unplug the unit. Turning the
power switch off does not disconnect the unit completely from the MAINS.
Severe damage may result if the AC voltage setting is not correct for the AC power
available in your area.
 See section on “AC Mains Connection” for instructions on selecting the proper AC
voltage setting. Product failure caused by improper voltage setting cannot be
covered under warranty.
 Liquid entering the product enclosure is likely to cause performance degradation or
failure. Failures due to moisture entering the enclosure cannot be covered under
warranty.
 This product is designed to operate in an ambient temperature environment not to
exceed 50 C (122F). Please ensure that this unit is mounted in such a way that sides
and rear of unit have minimum ¾” (19mm) clearance, and ambient temperature does not
exceed 50
C.