TRUE Systems PRECISION 8 - Manual (Page 2)

2
SAFETY and OPERATING PRECAUTIONS
Important Information:
This symbol indicates the presence of dangerous voltage within the product
enclosure that presents the risk of electric shock injury. When this symbol
appears next to an operation discussed in this manual, only qualified
technical personnel should perform that operation.
This symbol indicates important operating or maintenance instructions that
should be read carefully. Failure to observe these instructions could result in
damage to the product or other property.
WARNINGS:
• To reduce the risk of electric shock injury, do not remove the top cover or rear
panel. Uninsulated dangerous voltage exists within the product’s enclosure.
Refer servicing to qualified personnel.
• Do not defeat the earth ground connection in the AC power cable. Tips for eliminating
ground loops are discussed in the “
TROUBLESHOOTING” section of this manual.
• Do not operate this unit in the presence of rain, liquids or condensing moisture. Liquid
entering the product enclosure presents the risk of electric shock injury. Do not touch
the AC plug or enclosure with wet hands.
• Do not defeat intended AC power connection polarization.
• Do not use a damaged or excessively worn cord to connect this unit to AC power.
CAUTIONS:
• Severe damage may be caused to your unit if it is connected to an AC power
source other than 120VAC, 60Hz. See section on “AC Mains Connection”. Product
failure caused by improper voltage application will not be covered under warranty.
• Do not operate this unit in the presence of rain, liquids or condensing moisture. Liquid
entering the product enclosure is likely to cause performance degradation or failure.
Failures due to moisture entering the enclosure will not be covered under warranty.
• Should liquid spill on the unit, immediately disconnect it from the AC power source and
return it to your dealer or
TRUE Systems for servicing.
• This product is designed to operate in an ambient temperature environment not to
exceed 50
° C (122 ° F). Please ensure that this unit is mounted in such a way that vents
are not blocked and ambient temperature does not exceed 50 ° C.