TruTrak Sorcerer RV10 AP100 - Manual (Page 5)

Sorcerer, RV 10, AP 100 Autopilot Installation Manual 3 TruTrak Flight Systems
May 2009 8300-010 Rev B
Specific connections for certain commonly-used in-panel GPS units
Note that the information in the tables is based upon the best information available from each manufacturer’s documentation at
the time of publication. Please consult the appropriate installation manual for confirmation of wiring information.
Garmin 430 and 530 connections to Sorcerer autopilot
P4001 [P5001] on
Garmin 430 [530]
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
Sorcerer Autopilot
21 MAIN +LEFT CDI LEFT 21
22 MAIN +RIGHT CDI RIGHT 22
27 MAIN +UP GS UP 24
28 MAIN +DOWN GS DOWN 23
56 GPS RS 232 OUT 1 Primary Serial Input 25
46 GPS ARINC 429 OUT A ARINC-A 26
47 GPS ARINC 429 OUT B ARINC-B 27
14 ILS / GPS APPROACH Localizer Mode 29
Garmin 430/530 setup instructions:
Power 430/530 up and turn it on while holding down the ENT key. Release the ENT key when the display activates. After the
data base pages, the first page displayed is the MAIN ARINC 429 CONFIG page. While in Configuration mode, pages can be
selected by ensuring the cursor is off and rotating the small right knob. To change data on the displayed Configuration Page,
press the small right knob (CRSR) to turn on the cursor. Turn the large right knob to change between data fields. Turn the
large or small right knob to change a field that the cursor is on. Once you have made the desired selection, press the ENT key
to accept the entry. The second startup page will test the RS 232 and ARINC inputs on the ground, a good RS 232 connection
will display GPS NAV and the asterisk, ARINC will display GPSS and move the stick right and left.
With the MAIN ARINC 429 CONFIG page displayed, on the row labeled OUT, select SPEED Î Low
and DATA ÎARINC 429 GAMA, turn labels ON.
Advance to the MAIN RS232 CONFIG page.
On the row labeled CHNL1, select OUTPUT Î Aviation.
Note that for the Garmin units, the autopilot will need to be set for 9600 baud.
Garmin 480 connections to Sorcerer autopilot
P1 on GNS 480 Signal Name (Garmin AT) Signal Name (TruTrak) P101 on Sorcerer
22 RS232 TxD2 Primary Serial Input 25
P5 on GNS 480 Signal Name (Garmin AT) Signal Name (TruTrak) P101 on Sorcerer
4 429 OUT 1A ARINC-A 26
24 429 OUT 1B ARINC-B 27
P7 on GNS 480 Signal Name (Garmin AT) Signal Name (TruTrak) P101 on Sorcerer
14 MAIN CDI + LEFT CDI LEFT 21
13 MAIN CDI + RIGHT CDI RIGHT 22
30 MAIN CDI + UP GS UP 24
31 MAIN CDI + DOWN GS DOWN 23
33 ILS Energize Localizer Mode 29