Tuffy Security 256 - Manual

Page 1 of 2 - 12/3/2010 – Rev--
INSTALLATION INSTRUCTIONS
66-77 Early Ford Bronco
Conceal Carry Security Drawer #256
(Fits vehicles with original seat brackets/mounting)
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
#1 Enclosure #3 Drawer #5 Storage Tray #7 Bracket
#10.1 - (5) #10 x ½” Screw #10.2 - (5) #10 washer #10.3 - (5) #10 Nylock nut
#10.4 – (1) 5/16”x1” Torx Bolt #10.5 – (2) 5/16” washer #10.6 – (1) 5/16” Nylock nut
TOOLS NEEDED
•
3/8” and ½” Sockets and Ratchet
•
#2 Philips head screwdriver
•
Electric drill (Optional)
•
T-40 Torx bit (Optional)
•
Marker or pencil
•
Knife
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
Warning! Do not operate the vehicle without the drawer locked shut. If left unlocked
normal vehicle movements while driving could cause the drawer to open creating an
unsafe situation.
Note: To remove the drawer from the enclosure, pull the drawer out as far as it can go then
locate the small black plastic stops visible on the ball bearing drawer slides. One of the black
stops will need to be deactivated by pressing down and the other one pulled up. Be careful not to
break these plastic stops. While deactivating the stops push the center slide section back into the
drawer enclosure off of the front slide section attached to the drawer until they are separated. To
reinstall, line up the slide sections and push the drawer in gently, do not force it or it can be
damaged.