Figure 1 figure 2 – Tuffy Security 256 User Manual
Page 2
Page 2 of 2 - 12/3/2010 – Rev--
1. Assemble the Storage Tray and Mounting Bracket to the Enclosure using the #10.1 screws,
#10.2 washer, and #10.3 nuts. Install the washers on the exterior. (See Figure 1)
2. Remove the original seat mounting bolts #10.8.1 holding the front of the Passenger side seat
to the body. (See Figure 2)
3. Insert the drawer in the mounted position. Make sure both the enclosure mounting flange
and the #7 Bracket are under the original seat brackets #10.8 as illustrated. (See Figure 2)
OPTIONAL SECURITY STEP
WARNING! - Make sure that there is nothing under the vehicle that will be damaged by the drill
bit when drilling.
For additional security, mark the spot in the vehicle floor #10.7 under the additional hole in the
drawer enclosure mounting flange and drill a 3/8” hole. Fasten using the included bolt #10.4,
washers #10.5 and nut #10.6. It is recommended to use silicone sealant on any drilled holes to
prevent rusting. (See Figure 2)
4. Fasten the Tuffy drawer down using the original seat mounting bolts #10.8.1. (See Figure 2)
Figure 1
Figure 2
Call (970)564-1762 for Technical Support