Twin Eagles TEEH-3524 - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
– ELECTRIC HEATER
NOTE :
a) The heater must be permanently installed and hard wired by a licensed contractor.
b) Twin Eagles electric heater is shipped with the heating element uninstalled to prevent it from
breaking from any possible shipping impact.
c) Assembly procedure must be performed with no electrical power to the unit.
1) When you open the box, all components should be organized as seen on the picture. Remove the box
with the element and place it in a safe area, you will it need later on. Remove the rest of the cardboard
inserts including the mounting brackets on each side. Then take the heater out of the box and place it on a
flat surface.
2) Look at the rear area of the heater unit and reference the UL label for the electrical requirements. The
electrical requirements should either be;
i. 120V (1500W) (TEEH-1512)
ii. 240V (2500W) (TEEH-2524)
iii. 240V (3500W) (TEEH-3524)
A) Once electrical requirements on the heater have been identified, compare it versus the elements
electrical rating they’re to be the same. If the two electrical requirements are not the same, contact
the customer service department. If they are the same, continue by removing the end-plates on each
side.
B) Open the hold-down-clip on both sides and CAREFULLY install the heating element (no polarity) and
remove the outer nut ( 11 /
32
”) and insert the round wire terminal into the element end. Place the outer
nut back in and tighten the outer nut while holding the inner nut with a second wrench. Be careful not
to damage the element’s ceramic ends during this process. If connection is left loose it could cause
element to fail. Then bring down the hold-down-clips on both sides. With the use of a cloth, wipe
the element and reflector to eliminate any finger prints or debris.
C) Install the front grill safety cover by pushing the legs into the seam as seen on picture “C”.
D) Screw the end plates back on and remove the protective blue plastic.
2
Mounting
brackets Element
enclosed
Electrical
junction box
11 /
32
”
Inside &
outside
nut
End Plates
Hold-Down-Clip
UL Label
Front Grill Safety Cover
Heating
Element
A)
B)
C) D)
Ceramic