Twin Eagles TEEH-3524 - Manual (Page 5)

MOUNTING INSTRUCTIONS
– ELECTRIC HEATER
The following information is provided to direct you on how and where to mount
T WIN E AGLES
ELECTRIC HEATERS. Our heaters may be the most economical to install, depending on the location of
electrical power adequate to operate the heater (s) properly. All models come with standard wall-ceiling swivel
mounting brackets for each side…which MUST be used. All hardware is included; reference pictures below to
install the brackets to the heater unit.
HEATING AREA COVERED
(ref. bottom of pg. 4)
Model Volts Watts Amps
Heater
Weight
Heater
Length
Mounting
Height
(ft.)
Cold-
Breezy
(ft.)
Mild
(ft.)
Well
Protected
(ft.)
*TEEH-1512 120 1500 12.5 7
Lbs.
33” 7 3 x 3 5 x 5 7 x 7
TEEH -2524 240 2500 10.4 8
Lbs.
39” 8 5 x 5 7 x 7 9 x 9
TEEH -3524 240 3500 14.6 13
Lbs.
61 ¼” 9 7 x 7 9 x 9 11 x 11
4
Swivel
Mounting
Bracket
Swivel
brackets
allow the
heater to be
tipped up to a
60 o angle.
Swivel
Point
ALWAYS maintain the minimum required clearances from heater
body to combustible materials. Installation must be such that 18”
minimum clearance is maintained between Heater and vertical
surfaces. The heater may be wall mounted 12” minimum from the
ceiling while maintaining 18” minimum clearance at the ends.
Heaters, if mounted in tandem, should be at least 3 feet apart.
Vertical Wall Mounted
Horizontal Ceiling Mounted
Twin Eagles Electric Radiant Heaters are UL safety-approved for
both outdoors & indoors. *We recommend model TEEH-1512 (120V,
1500W) to be used in enclosed areas or wind protected areas. For
Outdoor or breezy areas, we recommend models TEEH-2524 (240V,
2500W) &/or TEEH-3524 (240V, 3500W) .
For the best comfort heating it’s usually best to radiate heat onto
heating area from two sides rather than from just one side. There are
times when it is not practical, in either scenario, reference the
information below on this page for heating areas.
240V
(2500 or 3500W)
Outside View
Inside View
NOTE: DO NOT mount the heater on a vertical axis. Such installation will reduce
the life of the element and will automatically VOID the product’s warranty. For
maximum element life, use a level to find the Horizontal Axis position of the heater
body. Heater must be leveled but can be swiveled on its horizontal axis.