TYREDOG TD-1300A-X5 Owners Manual - Manual (Page 21)

20
Warning values can be set for each axle and the spare tyre separately.
When setting each warning value, the corresponding axle will flash with the
value being adjusted (1+2, 3+4, Spare)
When Light is pressed after the last setting, the home screen will be shown.
+
Replacement Sensor Learn Mode
If in any case a sensor is lost, stolen or damaged, it can be replaced with a
‘Learnable Sensor.’ These sensors have their own special code and can only
replace those of the same type and wheel location. For example, if sensor FR is
damaged, it can only be replaced by a ‘FR Learnable sensor.’ Learnable sensors
can be purchased individually at an authorized Tyredog reseller.
To enter learn mode, provide power to the monitor while holding the LIGHT
button. Continue holding the temp button until ‘LEN’ is shown in the four corners
of the screen. You must continue holding the Mute button until ‘LEN’ is displayed
or Learn Mode will not be initiated.
Once the system is in learning mode, you can proceed to program your new
learnable sensors. Simply insert the battery into the learnable sensor to activate
its code in the monitor’s memory. When the code is learnt, the monitor will beep
once, and the new code will be displayed in the corresponding wheel location on
the display as shown in the following image.