Contec 4(FIT)GY 1 - Manual (Page 4)

Ver.1.00
DIO-4/4(FIT)GY 4
Using Outputs Y0
Mo
du
le
s
id
e
Load
Output pin (e.g., connector Y1)
Output minus common
External
power supply
12V - 48VDC
+
- Output plus common
Example of Connecting Outputs and Inputs
12V - 24VDC
Output module
Output
Common minus for output
Common plus for output
External
power supply
+ -
Intput
Common plus for intput
Intput module
The controller module distinguishes and keeps track of the
modules that are connected to it by assigning device IDs to
them. Each module, therefore, should be assigned a unique
ID.
A Device ID can be assigned in a 0 - 7 range, so that a
maximum of eight modules can be distinguished.
The factory setting for the Device ID is [0].
Setup Method
A Device ID can be set by turning the rotary switch that is
located on the module face.
A Device ID can be assigned by turning the switch.
Device
ID
0
4
0
4
6
2
5
1
3
7
Factory setting:
(Device ID = 0)
Setting a Device ID