USL JSD-100 Manual - Manual (Page 23)

Page 22
Tabs
The remainder of the GUI window contains tabs that divide the remaining configuration data into logical groups.
Each tab will be discussed in sequence.
Summary Tab
The “Summary” tab (view shown right) gives
a broad view of the JSD-100 and its
installation. The Theater Information fields
may be changed as needed. The other
sections of this screen cannot be changed
through the summary tab.
Component Information
The PIC firmware version identifies the
firmware
version in two of the
microcontrollers and the circuit board
revision of the main circuit board. In the
sample screen above, the first E indicates this is board revision E. The 110630 is the revision of the main processor
firmware. The 110512 is the revision of the rear panel processor firmware. This tab also shows the versions of the
firmware for each of the two digital signal processors and the version for the GUI software itself. Each of these
version numbers can be compared with later updates to determine if the latest firmware is already installed.
Network Information
This is the network information that was set with the JSD-100 Set IP Utility, discussed previously.
Formats Tab
The “Formats” tab allows the setting of “Per-Format” configuration. These settings apply only to a specific format.
The type of settings available varies by format type. The available settings for each format are listed below. Select
the format that is to be configured using the format buttons on the GUI or the JSD-100 front panel.
Format Settings
Coax 1 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
Coax 2 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
TOSLINK Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
Digital 16 Channel Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, HI/VI
Source
User 1 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Input
Select, HI/VI Source, Decode Options
User 2 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Input
Select, HI/VI Source, Decode Options
Analog 8 Channel Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, HI/VI Source
Non/Sync Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Decode
Options
AUX Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Decode
Options
Mic Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Mic
Phase