USL JSD-100 Manual - Manual (Page 32)

Page 31
Adding Groups
Create a group for each theater. The group is a collection of JSD-100s, one in
each auditorium.
Click the “Groups” button at the top of the screen.
Click “Add”. You will be prompted to enter the name of the new group.
Click “OK” when you have finished adding groups.
Adding Auditoriums
Click the “Auditoriums” button. The Add Auditorium dialog box will
appear.
Click “Add” to add an auditorium.
The name of the auditorium can be changed as desired.
Select the group from the previously defined list of groups.
Click “Change” under Communications Settings to
set the IP address of the JSD-100 in this auditorium.
Select the IP address of the JSD-100 from the auto-
detected device list if it is present. If not, press
“Manual Add” and then key in the IP address of the
JSD-100 in this auditorium.
Press “OK” to exit Comm Settings and OK to exit
Auditoriums.
Once groups and auditoriums are defined, the GUI
shows a summary view of each JSD-100 on the
network. The summary view includes the selected
format, the fader level, and communications settings.
Clicking on the summary view box brings up the
detailed view of that particular JSD-100 where all
controls are available.