USL DAX-602 - Manual (Page 12)

DAX-602/802 INSTRUCTIONAL MANUAL Ultra
★ Stereo Labs, Inc.
Using IP Autoconflguration and NETBIOS
If no network with a DHCP server is available, connect a computer to the DAX
using a network "crossover" cable. Some recent computers can use a standard
"straight through" cable, but a crossover cable will always work.
Many computers support "IP Autoconfiguration" where the computer chooses an
- IP address in the 169 254.x.y range. With such computers, once again, opening
a web browser and typing "DAX" in the address field will connect you to the DAX
unit and show the status screen.
Using Default IP Address
If your computer does not support IP Autoconfiguration or NETBIOS, you should
configure your network connection to be in the same subnet as the DAX, and set
its IP address to something other than that of the DAX. For example, you may set
your computer to have an IP address of 169.254.1.123 and a subnet mask of
255.255.0.0. Then, type the default DAX IP address (169.254.1 .I) in the address
field of your web browser. You should see the status page.
Configuring the DAX Network
Once the status page is visible, you can select the configuration page (link at top
of status page) The system will ask for a user name and password. The user name
is "admin" and the default password is "ultra" (both lower case).You can change
the password on the configuration page.
DAX-602 Configuration Page
-12 -