USL DAX-602 - Manual (Page 13)

DAX-602/802 INSTRUCTIONAL MANUAL Ultra
★ Stereo Labs, Inc.
On the Configuration Page, you can change the Host Name (NETBIOS name) the
device responds to. If you disable DHCP, you can set a static IP address,
gateway, subnet mask, and DNS servers. DNS servers need not be specified.
Once these are set, click on "Save IP Config and Reboot." The DAX will restart
with the new configuration. You will need to key the new IP address in to the
address field of your web browser to re-establish contact.
Changing Surround Delay
The surround delay can be changed on the Configuration Page. The delay can be
between 0 and 150ms, inclusive, with a resolution of 1ms. Key the desired delay
in to the appropriate field and click on "Save Audio Config" to save this value.
The DAX allows the surround delay to be set either on the unit Itself (rear panel
rotary switch) or through the web browser. Whichever setting was done most
recently is the setting the system will use. The red "Active" LED next to the switch
will light when the switch shows the current delay. If the LED is out, the delay has
been set remotely. The switch setting can be changed to restore control to the
switch (and the red LED will light).
Auditorium Data
Users can specify various pieces of auditorium data. Each field accepts up to 20
characters. The theater name and screen number are shown at the top of the
status page so users can quickly identify which system they are viewing.
Change Password
To change the password required to reach the configuration screen, type the new
password in the two fields. The two values must match for the new password to
be accepted. Passwords are limited to 10 characters. Passwords are case
sensitive. Should you lose the password, a system restore (described below) will
be required to restore the default password.
Updating Firmware
The Configuration Page has a link to the Update Firmware page.
-13 -