Cisco 3200 User Manual
Page 184
10-2
Cisco TelePresence System 3200
OL-14521-01
Chapter 10 First-Time Setup
Loading CTS Administration Software
Note
Make sure that you power on all codecs within 30 seconds to avoid power on detection failure.
After you turn on the codecs, the displays associated with each codec becomes active. CTS displays
green check marks on all displays to show bootup progress. Bootup is complete when the system
displays six check marks as shown in
.
Figure 10-1
Bootup Completed
Note
If the last check mark displayed is a red “X,” there has been a compact flash error. Please contact Cisco
Technical Support.
After bootup completes, make a note of the IP address that displays on the center of the screen as shown
in
. You use that information to log in to the Cisco TelePresence System Administration. This
IP address displays until you log in to Cisco TelePresence System Administration or use Secure Shell
(SSH) to log in to the CTS-3200.