Cisco 3200 - Manual (Page 44)

5-2
Cisco TelePresence System 3200
OL-14521-01
Chapter 5 Building the Lighting Assembly
Parts List
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Caution Metal and plastic edges can be sharp. Cisco recommends you wear safety gloves and safety glasses when
attaching the lighting assembly.
Caution Some system components have metal and plastic edges with hard angles. These edges are exposed until
you complete system assembly. Use caution when you move around the system during assembly to avoid
contact with any exposed system edges.
Note The directions left and right refer to the assembly as you face the Plasma displays.
23 Light “cup” bracket 700-23737-xx 2 43
24 5-foot center light fixture 74-5361-xx
CTS-LT-FX-
5FT-GN
Kit #95-8932-xx
3 31 See “Appendix B: Region- and
Country-Specific Equipment” for
Europe- and Japan-specific lighting
fixtures.
25 4-foot side light fixture 74-5362-xx
CTS-LT-FX-
5FT-GN
Kit #95-8932-xx
2 30,
31 See “Appendix B: Region- and
Country-Specific Equipment” for
Europe- and Japan-specific lighting
fixtures.
26 M8 x 70 mm screws 48-2274-xx 10 1
27 M8 x 16 mm pan head screw, white 48-2432-xx 1
28 M8 x 20 mm flat head screw, white 48-2433-xx 10 49
29 Diffuser Panel braces / H-clips 700-25050-xx 2 49
30 Compliance sticker for plasma display 47-21525-xx 1 1
31 M8 x 16 mm pan head screw, black 48-2430-xx 2 1
32 Reflector bottom tray: right side top 700-27762-xx 1 49
33 Reflector bottom: right end 700-27763-xx 1 49
Touch-up paint, white 74-5247-xx 1 1 Use this paint on the light reflectors to fix
any minor cosmetic issues caused by
shipping and handling.
Key Part Description Part Number Qty Ctn Notes