Winco Fuel Shut-Off Solenoid Kit HPS6000HE/I & HPS9000VE/E (2013) - Manual (Page 3)

3 3256-00 64854-005I
Remove the bolt (A) holding the demand regulator down and rotate the demand
regulator. This allows for turning of the pipe nipple and solenoid.
Thread the pipe nipple (ref. 7) onto the 90° elbow using pipe sealant.
Thread the gas solenoid valve (ref. ) onto the pipe nipple using pipe sealant.
Make sure the solenoid end marked “OUT” is toward the generator and the
solenoid end marked “IN” is toward the supply line.
Tighten with a pipe wrench.
Replace demand regulator bolt.
Connect wires labeled  & 2 from control box harness to the solenoid. Polarity
does not matter.
•
•
•
•
•
•
•
STEP 2 HPS9000VE/E
STEP 3 HPS6000HE/I
Take battery positive cable loose from starter solenoid (A). Route RED wire # 2
through the rubber cable protector (B) and re-tighten starter solenoid nut (C).
Take battery negative cable loose from engine base (D). Place BLACK wire # 
under the bolt and re-attach battery negative cable to engine base.
•
•
C
A
B
D
A