Winco 2-Wire Conversion Instructions ULPSS20B2W/A - Manual

INSTALLATION INSTRUCTIONS FOR 2-WIRE
AUTO START CONTROL CONVERSION
The following instructions are provided to convert the ULPSS20B4W/A
from a special 4-wire start system to a standard 2-wire Auto Start Sytem.
Items required:
WINCO Conversion Kit # 16448-008 Auto Start (for ULPSS20B2W/A)
T25 Torx Screwdriver
7/16” End Wrench or Socket & Driver
PROCEDURE
1. Remove rear door and large side door for easy access to the controls.
2. Move the left hand toggle switch “A”
to the “STOP” position.
3. Remove the battery negative (-) cable from the battery.