Winco 2-Wire Conversion Instructions ULPSS20B2W/A - Manual (Page 3)

8. Remove 4-wire control assembly.
9. Install the 2-wire control assembly in the same location as the 4-wire control.
10. Re-install the 4 torque screws from the back of the panel to secure the 2-wire
controller in postion.
11. Re-attach the black wire-loom connector on the left side of the controller.
12. Locate and connect the white plastic connector to the bottom of the new control-
ler assembly as shown in the picture below.
13. Pull the panel (C) out and down. Replace the bolt (B) that was set aside earlier.
14. Remove the right side panel.
15. Locate the 2-wire white connector on the right side of the engine. Unplug the
white connector and tie back if necessary. See picture below.