Crestron electronic Crestron Green Light DIN-HUB - Manual (Page 13)

Crestron DIN-HUB DIN Rail Cresnet
®
Distribution Hub
Setup
Network Wiring
When wiring the Cresnet
®
network, consider the following:
• Use Crestron Certified Wire.
NOTE: Cresnet-HP wire cannot be used.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the
system (
www.crestron.com/calculators ).
For more details, refer to “Check Network Wiring” on page 14.
Installation
The DIN-HUB must be installed by a licensed electrician, in accordance
with all national and local codes.
CAUTION: This equipment is for indoor use only. Mount in a well
ventilated area. The ambient temperature must be 0º to 40º C
(32º to 104º F). The relative humidity must be 10% – 90%
(non-condensing).
Operations & Installation Guide – DOC. 6671A DIN Rail Cresnet Hub: DIN-HUB
• 9