Crestron electronic Crestron Green Light DIN-HUB - Manual (Page 17)

Crestron DIN-HUB DIN Rail Cresnet
®
Distribution Hub
Problem Solving
Troubleshooting
The following table provides corrective action for possible trouble
situations. If further assistance is required, please contact a Crestron
customer service representative.
DIN-HUB Troubleshooting
TROUBLE POSSIBLE
CAUSE(S)
CORRECTIVE
ACTION
NET HOST
PWR LED does
not illuminate. DIN-HUB is not
receiving power. Determine that the
NET HOST port on the
DIN-HUB is properly
connected to a
Cresnet power supply.
Segment is
improperly wired. Verify wiring
connections: proper
connector is used,
cable in intact, and
connections are
secure.
Device(s) attached
to segment is not
properly identified
in SIMPL™
Windows
®
.
Use Crestron Toolbox
to verify that the SIMPL
Windows program
recognizes all of the
devices.
Segment’s NET
LED does not
illuminate.
Other segment is
improperly wired. Remove all segment
connections except for
segment attached to
control system and
segment for which the
LED is not illuminating.
(Continued on following page)
Operations & Installation Guide – DOC. 6671A DIN Rail Cresnet Hub: DIN-HUB
• 13