YSI 600LS - User Manual User Manual
Page 230
EcoWatch for Windows
Section 4
YSI Incorporated
Environmental Monitoring Systems Manual
4-34
Add/Remove
There are two lists, Selected Parameters and Available Parameters. If, for example, you wish
to graph another parameter, you must highlight it on the Available Parameter list and then click
the Add button to move it over to the Selected Parameters list.
This is also where you decide the order in which the parameters will appear in both the table and
the graphs. If you choose to have two traces per graph, then the first graph will have the first and
second parameters on this list, the second graph will have the third and fourth parameters and so
forth. The parameters will appear in the Selected Parameters list in the order that they were
added. To rearrange the order, highlight the parameter you wish to move and then use the up and
down buttons to move it to the desired spot in the order.
The TSS parameter (only available if your sonde has a Turbidity sensor) is a parameter that is not
part of your original collected data. TSS is calculated by EcoWatch, which uses the Turbidity data
and a set of correlation points that you enter. When you add TSS, a TSS calibration window will
popup and prompt you for a set of correlation points. For more information see Calibrate TSS.
Units
Select the units for any parameter. It will take you to the Change Parameter Units dialog box.
You may choose the units for each of the selected parameters. Many parameters have only one
possible choice of units. DO concentration, for example; can only be expressed in mg/L. pH has
no units at all.
- 3100
- 3200
- 5000
- 5200
- 5200A
- 5200A
- 5500D-1
- 5239 Dissolved Oxygen Probe
- 55
- 550A
- 556 MPS - Quick Start Guide
- 58
- Pro-BOD
- 60
- 63
- 650 MDS
- 9300 Photometer
- 9300 Photometer
- 9500 Photometer
- CR 3200 Thermoreactor
- CR 4200 Thermoreactor
- CR2200 Thermoreactor
- DO200
- EC300
- EC300A
- EC30A
- IFL 700 IQ
- IQ SensorNet 2020 XT Terminal
- IQ SensorNet FDO Sensor
- IQ SensorNet MIQ/A-MOD Module
- IQ SensorNet MIQ/A-PR Module
- IQ SensorNet MIQ/IC2 Module
- IQ SensorNet MIQ/IF232 Module
- IQ SensorNet MIQ/JB Module
- IQ SensorNet MIQ/JBR Module
- IQ SensorNet MIQ/PS Module
- IQ SensorNet MIQ/R6 Module
- IQ SensorNet NitraLyt Sensor
- IQ SensorNet SensoLyt Sensor 700 IQ (SW)
- IQ SensorNet Sensors Encoded Fieldbus Data
- IQ SensorNet TetraCon Sensor 700 IQ (SW)
- IQ SensorNet ViSolid Sensor 700 IQ
- MultiLab 4010P-1
- MultiLab 4010-2
- MultiLab 4010-3
- ODO200
- pH100A
- pH10A
- pH1200
- pHotoFlex pH Handheld Colorimeter
- pHotoFlex STD Colorimeter
- Pro1020
- Pro1030
- Pro20
- Pro2030
- Pro30
- ProDSS
- Professional Plus
- Professional Plus
- ProOBOD
- ProODO
- TruLab 1310P
- TruLab 1320P
- TruLine ORP 51
- TruLine ORP 50
- IoLine Micro – 3 in 1
- ScienceLine -- pHT - G
- TruLine 15
- TruLine 21
- Vertical Profiler Systems
- 52
- 6000UPG
- 610
- 610DM
- 6200
- 85
- 95
- 9600
- ADV6600
- BODAnalyst
- 30
- 556 MPS
- 600R
- 6500 Environmental Process Monitor
- 6500 Environmental Process Monitor
- 900 Chlorine Colorimeter
- 910 COD Colorimeter
- AmmoLyt Plus 700 IQ
- CarboVis 705 IQ
- CarboVis 705 IQ TS
- DIQ/S 182-MOD System 182
- DIQ/S 182-PR System 182
- DIQ/S 182 XT-4-MOD
- DIQ/S 182 XT-4-PR
- DIQ/S 182 XT-4 System 182 XT-4
- EcoSense DO200A
- 600DW-B Sonde
- APPENDIX F
- EcoSense pH100
- IQ S ENSOR N ET DIQ/S 182 XT
- IQ S ENSOR N ET Field bus linking
- IQ S ENSOR N ET MIQ/A
- IQ S ENSOR N ET MIQ/C6
- IQ SensorNet DIQ/CR3
- IQ S ENSOR N ET System 182
- NiCaVis 705 IQ
- NiCaVis 701 IQ NI
- IQ S ENSOR N ET NitraVis 70x IQ
- P 700 IQ Analyzer
- IQ S ENSOR N ET NitraVis 70x IQ TS
- SensoLyt serries
- IQ S ENSOR N ET TriOxmatic 700 IQ (SW)
- IQ S ENSOR N ET VARiON Plus 700 IQ
- IQ S ENSOR N ET TriOxmatic 701 IQ
- VisoTurb 700 IQ
- IQ S ENSOR N ET TriOxmatic 702 IQ
- MultiLab IDS 4120
- MultiLab 4210 ORP Electrodes
- MultiLab IDS 4320 Conductivity Probe
- 4010-2 pH Adapter DIN / BNC
- pHotoFlex Series
- TruLab pH 1110
- MIQ/Blue PS Set
- IQ S ENSOR N ET MIQ/CHV PLUS