H-B Instrument 701 - Manual (Page 2)

4. Press “DOWN” button one time to reverse the setting one step; hold “DOWN” button for 2 seconds and it will
reverse the setting by 8 steps/second
5. Press “TIME SET” button to confirm the setting and enter into the next setting function
6. The system will automatically exit if no key is pressed after 8 seconds
Setting the Alarm
1. Press “ALARM” button once to display AL1, press “ALARM” button twice for AL2 – press “ALARM” button 3 times
to exit the alarm function
2. The sequence of alarm setting is: HourMinuteExit
3. Press “UP” button one time to advance the setting one step; hold “UP” button for 2 seconds and it will advance
the setting by 8 steps/second
4. Press “DOWN” button one time to reverse the setting one step; hold “DOWN” button for 2 seconds and it will
reverse the setting by 8 steps/second
5. Press “ALARM” button to confirm the setting and enter into the next setting function
6. The system will automatically exit if no key is pressed after 8 seconds
7. To turn on the alarm, quickly press the “DOWN” button. The sequence is AL1 on/AL2 offAL2 on/AL1
offAL1,AL2 onAL1, AL2 off
NOTE:
The buzzer will sound as follows:
0-10 second: one beep per second
10-20 seconds: two beeps per second
20-30 seconds: four beeps per second
after 30 seconds: will continuously beep
Snoozing the alarm
• Press “SNOOZE” button once to enter into 5 minutes of snoozing
• Pressing any other key will turn off the alarm
°F/°C Exchange
• To change from °C to °F, quickly press the “▼” button located on the back of the unit
• To return to °C, quickly press the “▼” button again
Location Selection
• To change city, press “LOCATION” button for 3 seconds
• Use “UP” and “DOWN” buttons to view the cities – select the nearest European city
• Press “LOCATION” button to confirm city
Sunrise/Sunset Selection
• After choosing the city, it will automatically calculate the time of sunrise/sunset of that city every day
Moon Phase Selection
• After choosing the city, it will automatically calculate the moon phase
Max/Min Readings
• Press “MAX/MIN” button to display the maximum temperature and humidity
• Press “MAX/MIN” button again to display the minimum temperature
• Press “MAX/MIN” button again to exit
• To clear max/min memory, hold the “MAX/MIN” button for 3 seconds
Temperature Alert Setting
• Press “ALERT” button to turn temperature alert on/off
• Hold “ALERT” button for 3 seconds to enter temperature alert setting
• Use “▲” and “▼” arrows located on the back of the unit to set the maximum temperature
• Press “ALERT” button to set the minimum temperature using the “▲” and “▼” arrows
• Press “ALERT” button again to exit
• The default temperature alert is 50°C (maximum) and 0°C (minimum) for indoor sensor and 70°C (maximum) and
-50°C (minimum) for RF sensor
Barometric Pressure Setting