Ram Trucks 2015 ProMaster - Diesel Supplement User Manual
Page 58
MESSAGE
DESCRIPTION
Press Brake Pedal / Startup
Delayed
This messages appears when the key is first turned ON, if the brake pedal
is not depressed and/or the shift lever is not in NEUTRAL (N). The shift
lever must be in the NEUTRAL (N) position, and the brake pedal must be
pressed, to allow engine cranking. Place the shift lever in NEUTRAL (N)
and apply the brake pedal BEFORE turning the key to the START/AVV
position; otherwise, the engine will not crank and the key must be cycled
OFF, then back on, before cranking is allowed.
Gear Unavailable
This message appears, along with a warning buzzer:
• When it is not possible to change gear due to a fault in the system.
• When, due a fault in the system, it is only possible to engage 1st (1),
2nd (2), 3rd (3) or REVERSE (R).
Contact your authorized dealer if the message continues to appear.
Shift Not Allowed
This message may appear when starting the engine at low temperature.
In this case the Automated Manual transmission isn’t able to engage first
gear, in this situation either use the engine block/transmission heater
or allow the engine to idle in NEUTRAL (N) until the transmission
has warmed.
56 STARTING AND OPERATING