Coway BA13-BE - Manual (Page 18)

17
as the bidet should be installed on the toilet, ensure that water is not splashed onto
the bidet.
there may be some water remaining inside the filter which was used to test the product
during the inspection process at the factory. this does not mean that the product was
previously used.
tips
InstaLLIng your BIdet
removing existing toilet seat
Installing the product
cold main water supply
make sure that the bidet is connected to the cold water pipe.
(If the product is connected to the hot water pipe, this may damage the filter and hose).
caution
2. connect the rubber packing, t-shaped connector, and water tank hose in
this order to the existing water pipe. Please connect the bidet hose to the
t-shaped connector.
Please ensure that the rubber packing is inserted between the water pipe and
the T-shaped connector.
Firmly tighten the nuts below and on top of the T-shaped connector all the way
to the end in a clockwise direction.
1. turn off the main water supply valve ① and separate the existing water
tank hose ②.
1. remove the existing toilet seat ① and seat cover ② by removing the fixing
nuts.
Keep the removed toilet seat in a shaded location to prevent it from being damaged.
tips
1210964 BA13 사용설명서_수출영문_(09.03.23).indd 17 2009.3.24 10:13:16 AM