Carrier 48TJ016-028 - Manual (Page 41)

Evaporator Fan Service and Replacement
48TJ016 UNITS (See Fig. 51)
NOTE; To remove belts only, follow Steps 1-6.
1. Remove filter and supply-air section panels.
Remove unit top panel.
Loosen carriage nuts A tmd B holding motor mount
assembly to fan scroll side plates.
Loosen screw C.
Rotate motor mount assembly (with motor attached) as
far as possible away from evaporator coil.
Remove belt.
7. Rotate motor mount assembly back past original position
toward evaporator coil.
Remove motor mounting nuts D and E (both sides).
Lift motor up through top of unit.
Reverse above procedure to reinstall motor.
Check and adjust belt tension as necessaiy.
48TJ020-028 UNITS (See Fig. 52) -- Tlie 48TJ020-028 units
use a fan motor mounting system that features a slide-out
motor mounting plate. To replace or service the motor, slide
out the bracket.
2 .
3.
4.
5.
6
.
8
.
9.
10
.
11
.
1
.
3.
4.
5.
6
.
7.
8 .
Remove the evaporator-fan access panel and the heat­
ing control access panel.
Remove the center post (located between the evaporator
fan and heating control access panels) and all screws
securing it.
Loosen nuts on the 2 carriage bolts in the motor mounting
base.
Using jacking bolt under motor base, raise motor to top of
slide and remove belt. Secure motor in this position by
tightening the nuts on tlie cturiage bolts.
Remove the belt drive.
Remove jacking bolt and tapped jacking bolt plate.
Remove the 2 screws that secure the motor mounting
plate to the motor support channel.
Remove the 3 screws from the end of the motor support
channel that interfere witli the motor slide path.
SECOND BELT
ON 10 HP MOTOR
NOTE: A 3V2-in. bolt and threaded plate are included in the
installer’s packet. They should be added to the motor support chan­
nel below the motor mounting plate to aid in raising the motor. The
plate part number is 50DP503842. The adjustment bolt is %-16 x
U
/4 in. LG.
Fig. 52 — 48TJ020-028 Evaporator-Fan
Motor Section
Fig. 50 — Evaporator-Fan Pulley and Adjustment
41