Chicago Electric 4 DRY TILE SAW 38941 - Manual (Page 11)

Page 11 SKU 38941 For technical questions, please call 1-800-444-3353.
WET CUT ATTACHMENT (38942)
(Please order separately- not included with the 4” Dry Tile Saw)
The Wet Cut Attachment includes a 1/4” I.D. x 9.5 foot vinyl hose, water plug with
screw and rubber connector
Assembly Instructions
Note: In step one (1) do not completely remove the Thumb Bolt.
1.
Loosen the Thumb Bolt (55), lower the guide, and re-tighten the Thumb Bolt.
2. Attach the Water Plug to the Water Tube (52) using the screw.
3. Connect the HOSE to the Water Plug.
4. Attach the Rubber Connector to the other end of the HOSE and connect to a water supply.
An additional adapter may be needed between the water source and the Rubber Connec-
tor. Water may also be fed to the unit by gravity feed when a water line is not assessable.
See the Gravity Feed instructions on the next page.
5. Turn water valve on the Water Plug counterclockwise to open and clockwise to close.
Thumb Bolt (55)
Water Plug
Figure 4 — Attaching the Water Supply Unit
(Tile Saw - Rear View)