Sears 580.761652 - Manual (Page 10)

• Reconnect the wand extension.
Note: After reconnecting the wand extension, you may
need squeeze trigger again on pressure washer wand to
relieve the air pressure caused by water inlet supply.
Water wiil spew out of the gun in a thin stream. This will
make it easier to puil start the engine.
To start engine for the first time,
• Push primer bulb firmly 5 times. If engine fails to start
after 4 pulls push primer bulb 3 times. Press trigger
on gun to release pressure after each pull.
•
Allow engine to run for two minutes before using.
• Once engine has started, place Safety Latch in the
DOWN position.
To start engine after initial start,
• Press the primer bulb 3 times, For warm engine, do
not prime,
• Press trigger to release water pressure.
• Grasp recoil handle and pull.
• If engine fails to start, repeat steps.
SIPHONING
We recommend that you DO NOT siphon your water sup­
ply, Connect only to household water supply.
TIPS
• Never use the garden hose inlet to siphon detergent
or wax.
• If you have the spray nozzle too far away, the clean­
ing will not be as effective.
MAINTENANCE
CUSTOMER RESPONSIBILITIES
MAINTENANCE SCHEDULE
FILL IN DATES AS YOU COMPLETE
HOURLY OPERATING INTERVAL
REGULAR SERVICE
MAINTENANCE TASK
Betore Each
Use
Every 25
Hours or
Yearly
Every 50
Hours or
Yearly
Every 1O0
Hours Of
Yearly SERVICE DATES
PRESSURE WASHER
Check/clean water inlet screen
on quick-connect.
xt
Check high pressure hose. X
Check detergent hose. X
Check spray gun and assembly for leaks. X
Purge pump of air and contaminants. X
encíme
Check oil level. X
Change engine oil. 4 X*
Service air cleaner. X**
Clean/replace spark plug. X
Prepare for storage. Prepare unit for storage if it is to remain idle for longer
than 30 days.
t Clean if dogged. Replace if pertoraied.
t .Change oil after first 8 hours of operation then after every 50 hours.
' Change sooner wrhen operating under heavy toad or high ambient temperature.
" Clean more often under dirty or dusty conditions.
J O