Sears 274.4394859 - Manual (Page 22)

Placing Channels in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
Using Advanced Features
Place channels in
memory (Autoprogram)
13
Controls Alarm Adjust
Enalish Français Español
Autoprogram ............
label: 13 , Clear
; Channel Memory: 13 Stored
'CableMIr: Cable
Label: 13 Clear
Channel Memory: 13 Stored
Cable/Air; Cable
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU»PROG repeatedly
to select the Setup Menu. This
menu is white.
C. Press MOVE T to highlight
Autoprogram.
D. Press MOVE ► to start the TV
adding all active channels into
memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
2. Add or delete channels 13
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13
Clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
Englls.h Français Español
Autoprogram
Label: 13
________ Clear
Channel Memory: 13 Erased
Cable/Air; Cable
A. Press MENU»PROG repeatedly
to select the Setup menu. This
menu is white.
B. Press MOVE T to highlight
Channel Memory.
C. Press MOVE ► to underline the
channel number.
D. Select the charmel number you
want to add or delete with the
number buttons.
E. Press MOVE ► to add or delete
a charmel (you will see Stored
on the screen when added and
Erased when deleted).
E. Repeat D and E for more
channels.
20