Sears 274.4394859 - Manual (Page 5)

Quick Guide to Your TV
Startup
5. Adjust PICTURE TILT.
Picture tilt is used to correct a
tilted picture from the effect of the
Earth's magnetic field on a large
picture tube. The PICTURE TILT
STRENGTH and POLARITY
switches on the back of the TV
compensate for this effect. If the
picture appears tilted, follow these
steps to improve it.
You may need to reset the
switches if the TV is moved or
repositioned in the room.
BACK OF TV
OFF HIGH
LOW
POLARITY STRENGTH
PICTURE TILT
A. Make sure S IRENG I H switch is
in the OFF position.
B. Move STRENGTH switch to the
LOW position. If this does not
fully improve tilt, move
STRENGTH switch to HIGH.
This should correct tilt. If moving
STRENGTH switch makes tilt
worse, return it to OFF and go to
the next step.
C. Change the position of
POLARITY switch. If this
improves the tilt but does not
fully improve it, move the
STRENGTH switch to LOW or
HIGH. This should correct tilt.
6. Place all available
channels in memory
(Autoprogram)
Details for adding and deleting
channels are on page 20.
13
Contiols Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13 Clear
Channel Memory: 13 Stored
Cable/Air; Cable
A. Press MENU»PROG until the
Setup menu is selected. This
menu is white.
B. Press MOVE T to highlight
Autoprogram.
C. Press MOVE ► to start placing
channels in the TV's memory.
D. Wait until TV has cycled
through all the channels and
returns to original channel.
7, Set the Time 12:21 AM 13
Controls Alarm Adjust Setup
Alarm: Off
Alarm Channel; 07
On Time: Disabled
Off Time: Disabled _________
Clock: Use-/+to set time.
A. Press MENU'PROG until the
Alarm menu is selected. This
menu is green.
B. The Clock is automatically
highlighted the first time you set
it. If it is not, press MOVE ▼ to
highlight it.
C. Press MOVE ◄ to set the hour.
D. Press MOVE ► to set the minutes.