Auto return turntable, Installation – Sears 565. 66480 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTO RETURN TURNTABLE
When a cook cycle is completed, the turntable will continue to turn until it reaches the same position
as it was at the start, if however, you open the door it will stop immediately even if it has not reached
the original position.
INSTALLATION
Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
1. Select a level surface that provides enough
open space (see illustration at right) for the
inlet and/or outlet vents.
• Leave a minimum clearance of 3 inches
(7.5 cm) above the oven.
• Do not remove the legs from the bottom of the
oven.
• Blocking the inlet and/or outlet openings can
damage the oven.
• Do not install oven over a range, cooktop or
other heat-producing appliance.
2. Plug your oven into a standard 120-volt / 60-Hz
household outlet. Be sure the electrical circuit
is at least 15 amperes and that your microwave
oven is the only appliance on the circuit.
A minimum clearance of 3 inches (7.5 cm)
is required between the oven and any
adjacent wall. One side must be open.
NOTE:
This unit is not designed for 50 Hz or any
circuit other than a 120-volt/60-Hz AC circuit.
This oven is designed for countertop
installation only. Insertion into a cabinet or
wall will damage the product and void the
warranty.