Sears 113.244501 - Manual (Page 19)

maintenance
WARNING: For your own safety, turn svifitch
‘‘OFF’, remove switch key and remove plug
from power outlet before maintaining
or lubricating your band saw.
Wiring Diagram
TIRES
Pitch and sawdust that accumulates on the tires
should be removed with a stiff brush or scraped off
with a piece of wood Do not use a sharp knife or any
kind of solvent
GENERAL
Keep your Band Saw clean
Remove sawdust from the irtside frequently
Do not allow pitch to accumulate on the table, blade
guides,
or thrust bearings Clean them with
Craftsman Gum and Pitch Remover
Apply a thin coat of automobile-type wax to the table
top so the wood slides easily while cutting Also apply
wax to the inside surfaces of the trunnion.
MOTOR/ELECTRICAL
Frequently vacuum or blow out any sawdust from the
motor
WARNING: If the power cord is worn, cut,
or damaged in any way, have If
replaced immediately.
WARNING: To avoid fire or electrocution,
reassemble electric parts with only approved
service parts. Reassemble exactly as
originally assembled.
LUBRICATION
All of the BALL BEARINGS are permanently lubricat­
ed They require no further lubrication
sears recommends the following accessories
Sears may recommend other accessories not listed in
manual
See your nearest Sears Store or Catalog Department
for other accessories
Do not use any accessory unless you have received
and read complete instructions for its use.
Item Cat. No.
Mifer Gauge........................................................ 9-24214
Blades (56-7/8" length}.......................... .......See Catalog
Leg Set........... ............................................... ...9-22244
Power Tool Handbook ........................................ .9-29117
19