Sears 113.244501 - Manual (Page 9)

INSTALLING THE BLADE
WARN!NG:Turn Off saw, remove swilch key
and unplug saw before removing or installing
blade.
1 Loosen the upper slide lock knob and position the
guide assembly about half way between the table
and the frame Tighten the lock knob
2 Open thè front cover of the saw by pulling forward
on the finger hold located on the left side of the
band saw
3 Remove the blade guard by loosening the screw
located on the side of the guard using a #2 phiilips
screwdriver Slide the guard up and pull forward to
remove it from the blade guide support
4 Unscrew the upper blade guides using a 1/8 inch
hex 'I" wrench and separate them about 1/8 inch
Repeal this step for the lower blade guides
NOTE; There is a patch on the blade guide(s)
threads that makes them difficult to turn This is nec­
essary to prevent rotation of the guides during opera­
tion of the saw
Loosen the setscrew which locks the upper blade
guide support (tocated on the left side of the sup­
port behind the bearing) Push the support all the
way back Loosen the setscrew holding the upper
back-up bearing (Located on the right side of the
upper slide). Push the bearing all the way back
With the guide
support and back-up bearing
pushed back, slightly tighten both set screws
Blade
Guide
Upper Slide
Upper Blade
Guide Support
Set Screw
Bearing
BLADE GUABO
HEMOVED FOB
CLARITY
Upper
Back-Up Bearing
Set Screw
Blade
Guide Support
Loosen the setscrew which locks the lower blade
guide support (accessed through notch in frame
located below table) Push the support all the way
back Loosen the setscrew holding the lower back­
up bearing Push the bearing all the way back
With
the guide support and back-up bearing
pushed back, tighten both set screws,